Conductivity - setup menu - conductivity range 6.6, Multi-parameter transmitter user’s manual – Aquametrix SHARK TX / TXP Transmitters User Manual User Manual

Page 54

MULTI-PARAMETER TRANSMITTER USER’S MANUAL

Conductivity - Setup Menu - Conductivity Range 6.6

Conductivity - Setup Menu - Conductivity Range 6.6

Page 52

DOWN

Conductivity Range will allow the user to select the
measuring range of the instrument.
The ranges can be selected from any of the following:
200 mS/cm - cell constant 50
20 mS/cm - cell constant 10

5000 uS/cm - cell constant 1

200 uS/cm - cell constant 0.1
20 uS/cm - cell constant 0.1
2 uS/cm - cell constant 0.01
19.99 M

Ω

- cell constant 0.01

With "N" selected, pressing the key
will NOT store the selection, but simply
return to the COND RANGE Menu. This
function is useful if you wish to view the
current selection without making any
changes.

Not stored

RUN MODE

NOTE

PRESS THE AND KEYS

TOGETHER TO GO IMMEDIATELY BACK TO

RUN MODE

DOWN

Then press the key to store the
selection and return to the COND
RANGE Menu.

Stored

Or press the key to highlight

the Y character.

Press the key to accept the
setting and move to the store function

Once the correct range is selected,
move to the store function to save the
selection

Press the key once
which will move the cursor back
to the RH side of the display.

Use the or keys to
scroll through the available ranges

Press the key once
which will move the cursor
over the last character of the
range.

STORE? Y N

COND. RANGE

20.00mS/cm

COND. RANGE

20.0 0 mS/cm

200. 0 mS/cm

19.9 9 Mo/cm

COND. RANGE

1000uS 25.0C

CALIBRATION

SETUP

UTILITIES

20.0 0 uS/cm

COND. RANGE

2.0 0 uS/cm >

200. 0 uS/cm

COND. RANGE

500 0 uS/cm >

COND. RANGE

5000uS/cm >

COND. RANGE