Aquametrix SHARK TX / TXP Transmitters User Manual - Manual (Page 57)

Conductivity - Setup Menu - Auto Return 6.9 Page 55
MULTI-PARAMETER TRANSMITTER USER’S MANUAL
Conductivity - Setup Menu - Auto Return 6.9
DOWN
Not stored
DOWN
Stored
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
DOWN
UP DOWN
DOWN
DOWN
DOWN UP
UP
NOTE
PRESS THE AND KEYS
TOGETHER TO GO IMMEDIATELY BACK TO
RUN MODE
DOWN
Then press the key to
store the selection and return
to the Auto Return Selection
Menu.
Press the key to
accept the change and move
to the STORE function
To change the MENU
RETURN setting,
Press the key once
which will move the cursor to
the ON or OFF text
MENU ON will cause the controller to exit the menu and
revert back to the online run mode after 10 minutes with no
buttons pressed. This feature ensures that if a user forgets
to return back to run mode, the controller will not be left in
an offline state. If for some reason, the user would like to
remain in the menu mode for extended periods of time, the
AUTO RETURN function can be set to "OFF".
AUTO RETURN is used to select what conditions
will cause the controller to time-out of the
operations menu
With "N" selected, pressing the
key will NOT store the selection, but
simply return to the AUTO RETURN
Selection Menu. This function is useful if
you wish to view the current selection
without making any changes.
Or press the key to highlight
the Y character.
RUN MODE
Use the or keys
to select either ON or OFF.
Press the key
once which will move
the cursor back to the
RH side of the display. MENU O FF >
MENU O N >
STORE? Y N STORE? Y N
AUTO RETURN AUTO RETURN
AUTO RETURN
UTILITIES
SETUP
1000uS 25.0C
CALIBRATION
TEMP SENSOR
TEMP UNIT
COND RANGE
AUTO RETURN
MENU ON
>
AUTO RETURN
MENU OFF >
AUTO RETURN
AUTO RETURN