Seed Hawk 30 SERIES 2014 - Manual (Page 62)

SEED HAWK ® 2014 30 SERIES OPERATOR’S MANUAL – DOMESTIC 56
5.7.5 Tramline Setup
The tramline function must be enabled to be used. Tramline control valves must
also be connected to the system harness for the monitor to show any opera-
tion function.
1. To enable the tramline operation,
press any of the
Soft Keys to bring
up the soft key menu. Then press the
“Tramline” button. Press
Enter again
to bring up the Enable/Disable menu.
2. Navigate to “Enable” and press
Enter. Navigate to “Sprayer Boom
Width” and press
Enter. A drop
down keypad will appear so the user
will be able to enter the width of the
sprayer.
IMPORTANT! The sprayer boom width must be a multiple of the Seeding
pass width. If the Seeding pass width is 30 ft. (9m) the sprayer boom width must
be 30 ft. (9m), 60 ft. (18m), 90 ft. (27m), 120 ft. (35.58m) etc. The seeding pass
width is the same as the implement width entered in Global settings and should
not need to be changed as is carries in from the global setting entry. It cannot
be accessed from this screen. If the user makes changes to these settings, cycle
the power on the monitor to reset all the values in the permanent memory.
3. “Start First Field Pass” resets the
register to pass #1 when it is set to
“YES”. To change this setting navigate
to this menu choice and press
Enter
then highlight the desired choice and
press
Enter. This menu selection
should normally be set to “NO” so
the pass register does not reset when
you access this screen.