Seed Hawk 30 SERIES 2014 - Manual (Page 36)

SEED HAWK ® 2014 30 SERIES OPERATOR’S MANUAL – DOMESTIC 30
5. Reinstall the bearing and locking pin and select a suitable gear setting. Close
the emptying hatch. If the latch clamp cannot be closed, open and clean so that
the emptying hatch lock can catch correctly.
6. Push in the shut-off hatch and fold down the latch clamp.
IMPORTANT! The grooves on the rapeseed rotor have to be guided into the
grooves on the seed box.
4.10 Gearing Up & Down
If the gear is changed with seed in the seed hopper, it is easiest to first close the
shut-off hatch and empty out the seed that is in the meter, refer to Section 5.10
on emptying the hoppers. Gear up or down as follows:
B
1. Pull out the locking pin (A).
2. Fit the locking pin in the inner
shaft's hole (B), near the end.
A
3. To switch from high to low gear,
rotate and press the shaft using the
locking pin.