Seed Hawk 30 SERIES 2014 - Manual (Page 59)

SEED HAWK ® 2014 30 SERIES OPERATOR’S MANUAL – DOMESTIC 53
5.7.1 Engage Drive
• There must be an implement
width entered.
• There must be a meter applica-
tion rate entered.
• There must be a meter calibration
rate entered.
• Forward travel speed must be
present.
• The drive must be engaged.
The monitor requires several pieces of information for field operation.
To engage the drive press the ACK button. The drive icon in the upper center
portion of the screen will turn solid. Engaging the drive will cause the furrow
openers to lower to seeding position and with travel speed present the rate
meters will begin to turn.
At the end of a seeding pass, press the
ACK button again to disengage the
meter drive. This will stop the applica-
tion rate meters and raise the furrow
openers. This will also stop the field
area accumulation register.
NOTE: The fans must be
running before engaging the
drive. If the fans are not
operating normally, an alarm
screen will display, alerting
the operator to the problem.
5.7.2 Disengage Drive
If all the installed sensors are found, the monitor will display a list of found sen-
sors. By pressing the soft key labeled “OK,” the operator can then access the
normal run screen. Items displayed on the run screen can be user selected and
the layout of the run screen can also be user selected. Refer to Section 5.3.4 for
more information. At this point the system is ready for operation.