Seed Hawk 30 SERIES 2014 - Manual (Page 41)

SEED HAWK ® 2014 30 SERIES OPERATOR’S MANUAL – DOMESTIC 35
5.2 Normal Start up
1. Press the Power button to begin.
2. As the Seed Hawk Logo is dis-
played, the monitor performs a self-
test. During this self test, the monitor
will check that all learned sensors are
connected.
3. Once this test is complete, all sen-
sors found by the system are listed as
shown in the image.
4. Press the soft key labeled “OK” to
continue to the Normal Operate
Screen.
NOTE: For everyday op-
eration, the monitor will
remember all settings that
have been saved from the
previous use.
Activate Drive Key: This key is used to engage your clutch or disengage your
clutch. (Reminder: Clutch Status is indicated in the Top Section of the
Display).
Meter Rate Screen: Pressing this button brings up a screen which allows
adjusting meter application rates and turning meters on and off.
Soft Keys: These keys allow the user to access specific functions within a
certain menu. The soft key options will be displayed along the right side of the
screen, which the operator can select by pressing the corresponding soft key.