Error message Page 63
Page 63

IM DA100-01E
3-4
No.
Error/Corrective Action
E0213
Can't open file.
Check the existence of the file. Check that the file system is operating properly.
E0214
Insufficient disk capacity.
Free disk space.
E0215
No such file.
Check the existence of the file.
E0216
Illegal file name.
Use a different file name.
E0401
Communication error.
The Logger Software cannot communicate while the setup software is communicating.
Check that the DARWIN is turned ON, the communication module is being recognized by the DARWIN (DR/DC), and the
cable is connected properly.
In addition, check the following items according to the communication methods.
For GPIB
Is the address correct? Is the driver is properly installed? Is the GPIB card manufactured by NI?
For Ether
Is the address correct? Is the TCP/IP protocol installed in Windows? Is the Ether card properly installed?
For RS-232-C, RS-422-A, and RS-485
Is the baud rate correct? Is the port (COM1 to COM4) correct? Is the address correct (RS422)? Is the PC's serial port
functioning? Is the correct type of cable being used?
E0404
Can't load DLL of GPIB.
Correctly install the GPIB driver.
Error message
No.
Error/Corrective Action
E3401
Incorrect Password.
Enter the correct password.
E3402
Passwords may not be blank.
Enter the password.
E3403
Project names may not be blank
Enter the project name.
Error message
No.
Error/Corrective Action
E3001
Incorrect File type or Version!The program will use default settings because the previous settings (such as display settings)
could not be loaded.
3.2 Error Messages