Yokogawa DA100 - Manual (Page 27)

IM DA100-01E 2-6
2.3 How to Connect the Input/Output Modules
Location and Location Number (Channel Number, Alarm Output Number, DI/DO
Number)
The location numbers correspond to channel numbers for locations where the input module is
connected, to alarm output numbers for locations where the alarm output module is connected,
and to DI/DO numbers for locations where the DI/DO module is connected.
In case of the DA100 Stand-alone type
The location numbers correspond to the location of each module as shown in the figure below.
Module 0 (Location numbers:001 to 010)
Module 1 (Location numbers:011 to 020)
Module 2 (Location numbers:021 to 030)
Module 3 (Location numbers:031 to 040)
Module 4 (Location numbers:041 to 050)
Module 5 (Location numbers:051 to 060)
In case of the DA100 Expandable type
The unit number (refer to the previous page, the number of the main unit is fixed at “I”) and
location numbers correspond to the location of each module as shown in the figure below.
Module 0 (Location numbers:001 to 010)
Module 1 (Location numbers:011 to 020)
Module 2 (Location numbers:021 to 030)
Module 3 (Location numbers:031 to 040)
Module 4 (Location numbers:041 to 050)
Module 5 (Location numbers:051 to 060)
Main unit
Unit No.:0
Subunit DS600
Module 0 (Location numbers:101 to 110)
Module 1 (Location numbers:111 to 120)
Module 2 (Location numbers:121 to 130)
Module 3 (Location numbers:131 to 140)
Unit No.:1
Subunit DS400
Input modules or transmission
modules cannot be connected.
Module 0 (Location numbers:101 to 110)
Module 1 (Location numbers:111 to 120)
Module 2 (Location numbers:121 to 130)
Module 3 (Location numbers:131 to 140)
Unit No.:I