Index – Yokogawa DAQWORX User Manual
Page 61

3-25
IM WX201-01E
Operat
on of the T
rend D
splay W
ndow
1
2
3
4
Index
The figure below shows an example of output when the Write Measured point of
the following channel check box is not selected, the smallest unit interval (reference
interval) is 0.5 s, and the number of steps is 1 (if the steps were set to 3, samples
would be output every 1.5 s).
CH01(1.5s)
Minimum unit interval
(0.5s)
CH02(0.5s)
CH03(1.0s)
CH04(2.0s)
CH05(1.5s)
: Measurement point of each channel
Output (0.5 s)
The squares represent the output of measured points on each channel (0.5 s)
If the Write Measured points of the followimg channel check box is selected
and channel 3 is also selected, measured points on each channel are output
every 1 s.
Note
• If the output points are not measured points, the points directly after are output.
• When the Write Measured point of the following channel check box is selected, the start and
end times on the right are those of the selected channel.
Example of the Converted Data
Notes When Convertng Data
• There is a limit to the number of data points that Excel and Lotus1-2-3 can handle.
Before executing the conversion, set the channels/groups to be converted, the
conversion range, and the step so that the number of data points is appropriate (see
Automatic Division Function for Conversion Output Files). In addition, if the free
memory space on the PC is low, you may not be able to load the data using Excel or
Lotus 1-2-3.
• If you set the save destination to a storage medium that has slow access such as a
floppy disk, the saving of the data may take an extended time. It is recommended that
such storage medium not be selected for the save destination.
• Select a save destination with adequate free space.
3.8 Convertng Data Formats