Yokogawa DAQWORX - Manual (Page 43)

3-7 IM WX201-01E
Operat
on of the T
rend D
splay W
ndow
1
2
3
4
Index
Mnmum and Maxmum Values of Scale, and the ndstart Scale Value
Dsplay Format nstop
You can set the maximum and minimum values of the scale when displaying waveforms.
The value in the Scale Min column is the lower end of the Y-axis, and that of the Scale
Max column is the upper end.
In the Form. column, you can specify floating point or exponential format for the scale
values.
Selects exponential display Waveform Display Screen
Settng the Waveform Dsplay Zones
You can set waveform display range for displaying trends. The waveform display
range is set as 0% at the bottom, and 100% at the top. The values in the Zone Min
and Max columns represent the lower (0-9%) and upper (1-100%) ends of the trend
display range.
Waveform Display Screen
Settng Trp Ponts
You can display a trip line to indicate a particular value of interest (trip point) in the
trend display area. Two trip points (trip 1 is red, trip 2 is blue) can be set for each
waveform. By selecting and clearing the check buttons in the Trip 1 and Trip 2
columns, you can select whether to display the corresponding trip points in the Trend
display screen.
Trip line ON/OFF
Waveform Display Screen
Trip line
Trip 1 value Trip 2 value
3.3 Settngs n the Channel Setup Screens