Yokogawa EJX930A User Manual
User’s manual
This manual is related to the following products:
Table of contents
Document Outline
- Contents
- 1. Introduction
- 2. About the EJX Multivariable Transmitter
- 3. Handling Cautions
- 3.1 Model and Specifications Check
- 3.2 Unpacking
- 3.3 Storage
- 3.4 Selecting the Installation Location
- 3.5 Pressure Connection
- 3.6 Waterproofing of Cable Conduit Connections
- 3.7 Restrictions on Use of Radio Transceivers
- 3.8 Insulation Resistance and Dielectric Strength Test
- 3.9 Installation of an Explosion-Protected Instrument
- 3.10 EMC Conformity Standards
- 3.11 Pressure Equipment Directive (PED)
- 3.12 Low Voltage Directive
- 4. Component Names
- 5. Installation
- 6. Installing Impulse Piping
- 7. Wiring
- 7.1 Wiring Precautions
- 7.2 Selecting the Wiring Materials
- 7.3 Types of Output
- 7.4 Connection
- 7.5 Wiring
- 7.6 RTD Cable Connection
- 7.6.1 Connecting Shielded Cable with Cable Gland (External temperature input code: -1, -2, -3, and -4)
- 7.6.2 Connecting Shielded Cable for Conduit Use (External temperature input code: -B, -C, and -D)
- 7.6.3 Removing Shielded Cable with Cable Gland (External temperature input code: -1, -2, -3, and -4)
- 7.6.4 Removing Shielded Cable for Conduit Use (External temperature input code: -B, -C, -D)
- 7.6.5 Cable Connection RTD Terminal Box Side
- 7.7 Grounding
- 8. Operation
- 9. Maintenance
- 10. General Specifications
- Revision Information