Yokogawa EJX930A - Manual (Page 43)

<7. Wiring>
7-6
IM 01C25R01-01E
(6) Turn the running coupler until the seal in the
entry comes into contact with the RTD cable.
YL P P U S
ESL UP
K C E H C MR A L A
F0720.ai
(7) Rotate the running coupler another half turn to
securely tighten the seal on the RTD cable.
(8) Use a protection conduit, if necessary.
In this case, insert the cable through the
conduit and attach it to the Backnut.
CAUTION
After the cable is secured as explained above,
do not tighten the running coupler any further; to
do so could damage the RTD connection.
Do not pull the cable or subject it to excessive
mechanical shock.
 In the case of electrical connection code F
(G1/2 female).
• Components for the cable gland
The cable gland assembly consists of an
adapter body, packing box, rubber packing,
washer, gland, clamp ring, clamp nut, union
coupling, and union cover.
Refer to (2) and (3) shown below.
RTD cable gland is accompanied by two kinds
of rubber packing.
Since the outside diameter of the RTD cable
is 8.5 mm, use the rubber packing with
identification mark “16 8-10” on it.
NOTE
The RTD cable can not let through the cable
gland from the connector side.
Insert the cable through the cable gland from the
wire rods side (opposite side of RTD connector)
before laying the cable.
Procedure
(1) Disassemble the cable gland: loosen the all
parts
(2) Remove the protection cap on the RTD
electrical connection and RTD connecting
port, and screw the adapter body to the RTD
electrical connection.
Screw the adapter body into the RTD electrical
connection until the O-ring touches the RTD
electrical connection (at least 6 full turns), and
firmly tighten the lock nut by the wrench.
SUPPL Y
PULSE
CHECK ALARM
F0726.ai
Be sure to apply a non-hardening
sealant to the threads for waterproofing.
O-Ring
Adapter body
Lock nut
Wrench
RTD electrical connection
(3) Insert the RTD cable in order of a packing box,
rubber packing, washer, gland, clamp ring,
clamp nut, union coupling, union cover from the
cable end of the wire rods side (opposite side of
RTD connector).
Since the internal diameter of rubber packing
has restriction, RTD connector can not pass
through it, please keep this order.
F0727.ai
Packing box
Rubber packing
Washer
Gland
Clamp ring
Clamp nut
Union coupling
Lock nut Wrench
Union cover
RTD connector
Insertion direction