Watlow Series 988LF - Manual (Page 39)

Operations
Operations Menu, Chapter 5 WATLOW Series 988LF Users Manual 5.7
Local-remote
Selects a local or remote set point. With [```r] selected the controller
displays the remote set point rather than the internal (local) set point, and
the set point cannot be changed with the Up-arrow > or Down-arrow <
key.
[`L-r] This prompt appears if [`rSP] (Setup Menu) is not equal to [`OFF].
Default
↓
[```L] [```r]
[`L-r] [`L-r]
[`L-r]
Auto-tune
Initiate an auto-tune.
[`AUt] This prompt always appears.
Default
↓
[`OFF] [``On]
[`CAL] [`AUt]
[`AUt]
NOTE:
For more information on
auto-tune, see Chapter
7.
Calibration Offset
Add or subtract degrees from the input signal. This allows you to
compensate for lead resistance, sensor errors, or other factors.
[`CAL] This prompt always appears.
If Default
↓ ↓
[-999] [```0] [9999]
[`CAL] [`CAL] [`CAL]
[`r†d] [-9(9] [```0] [99(9]
[``In] [`CAL] [`CAL] [`CAL]
[`CAL]