Watlow Series 988LF - Manual (Page 30)

Setup
4.8 WATLOW Series 988LF Users Manual Setup Menu, Chapter 4
Default Default Default
↓ ↓ ↓ ↓
(K) ``°F] [`°C]
[```H] [-328]…[2500] [-200]…[1371]
[```t] [-328]…[`750] [-200]…[`399]
[```n] ``32]…[2372] [```0]…[1300]
[```E] [-328]…[1470] [-200]…[`799]
(W5)
[```C] [``32]…[4200] [```0]]]…[2316]
(W3)
[```d] [``32]…[4200] [```0]]]…[2316]
[`Pt2] [``32]…[2543 [```0]]…[1395]
high impedance
[0-50] [-999]…[[`999] [-573]…[`573]
[```r] [``32]…[3200] [```0]]…[1760] 98_L-2__-AA__ only
[```S] [``32]…[3200] [```0]…[1760]
[```b] [``32]…[3300] [```0]…[1816]
[`rtd] [-328]…[1472] [-200]…[`800]
[`r†d] [-9(9]…[99(9] [-7#3]…[53&7]
process
[4-20] [-999]…[`999] units
[0-20] [-999]…[`999] units
[`0-5] [-999]…[`999] units
[`1-5] [-999]…[`999] units
[0-10] [-999]…[`999] units
[0-50] [-999]…[`999] units
[0=00] [-999]…[`999] units
Celsius-Fahrenheit
Select which temperature scale the controller will use.
[`C_F] This prompt appears only on controllers with either Input 1 set
to something other than a process input.
Default
↓
[``°f] [``°C]
[`C_F] [`C_F]
[`rL2]
[`rH2]
Range Low 2 and Range
High 2 continued from
previous page.
NOTE:
When high impedance
[`0-50] is selected for
Input 1, the range high
for both
[``°C] and
[``°F] can be extended
to [9999] . The range
low, when [``°C] is
selected, can be
extended to
[-999]
NOTE:
The range high
[`rH2]
value for process
inputs can be extended
to
[9999] .
NOTE:
These values do not
affect the low or the high
set point limit for
process alarms.
[`C_F]