Watlow ANASOFT - Manual (Page 83)

Appendix C: ANASOFT-RS
ANASOFT User’s Guide 73
Function Keys
R/S Time Base
Use the System Parameters window of the System Setup screen to select
the r/s time base. The time base can be either minutes:seconds or
hours:minutes. The time base affects all the other time units of all
profiles in the system (Time Remaining, Total Time, etc.).
R/S Loop Face Plate Display
When you assign a r/s profile loop to a system loop, r/s cycle
information will be displayed in the loop face plate display. Below is a
part of the Loop Overview screen displaying one standard loop and one
r/s loop.
Key Function
F1 Copy this profile to another profile name.
PgUp / PgDn Change segments.
ESC Return to Profile Assignment screen.
Standard control loop Assigned r/s loop
Cycle’s status. Five options.
See table on the next page.
Profile’s name
Current segment’s name
Cycle time remaining.
The time left until the
end of the segment.
Cycle total time. Total
time since the begin-
ning of the cycle.
Cycle number. displays the
cycle’s number out of the total
cycles. In this example the loop
is in the first cycle out of one
cycle.