Watlow ANASOFT - Manual (Page 51)

System Setup
ANASOFT User’s Guide 41
System Terminate
• This window allows you to terminate ANASOFT.
• Press Enter when the cursor is on the “Terminate Program” mes-
sage. The program prompts as follows:
Terminate Program (Y/N)?
If you have edited the current job without saving to disk, the following
message appears:
NOTE: The current job has been changed. To save changes to job file,
use the Save Job function of the Job Setup screen before terminating
the program.
If you entered Y, you will be asked whether to turn all outputs Off
before terminating.
Set Control Outputs Off (Y/N)?
WARNING
Turning control outputs off will shut down the
entire process.
• The program terminates and returns to the operating system.