Watlow ANASOFT - Manual (Page 82)

72 ANASOFT User’s Guide
Appendix C: ANASOFT-RS
.
Segment’s time duration. Set in minutes:seconds or
hours:minutes, depending on the time base defined in the
System Setup screen, System Parameters window.
Accumulation of all previous segments up to the edited seg-
ment. Changing Total Time also changes Segment Time.
Setpoint at the end of the
segment.
Setpoint’s tolerance. If the difference between
the PV and the setpoint is greater than the toler-
ance, the loop goes into tolerance wait status
until the PV is back within setpoint tolerance.
Set to -99 to +99 or to OPEN for no tolerance for
the segment.
Up to two triggers per segment. Each trigger can
be On or Off. Triggers can be latched or
unlatched. A latched trigger, once it becomes
active, is not checked again for the duration of
the segment. An unlatched trigger is checked
continuously during the segment.
Up to four events per segment.Set
to On or Off.
Number of cycles repeated automati-
cally. Set between 1 to 99 or Contin-
ues for continuous cycling.
An alarm is set when the PV is out of setpoint
tolerance for longer than the Timeout Tolerance.