Watlow ANASOFT - Manual (Page 50)

40 ANASOFT User’s Guide
System Setup
Save to EPROM (SYSTEM 32 only)
To save all operating parameters to the EPROM memory of the
controllers, move the cursor to the Save Parameters and press Enter.
When the controllers are powered up, they will operate with the
operating parameters saved in the EPROM memory.
WARNING
The operating parameters saved in the EPROM
memory should be safe operating values. When
powered up, the controllers operate at these
parameters until the ANASOFT program is
started and download operating parameters. Wat-
low-Anafaze recommends saving to EPROM a job
with all outputs set to manual and outputs at zero
percent as a safe power up condition.
Controller parameters
• Pulse Sample Time: This is the time base of the Pulse input (PLS).
It is adjustable from 1 to 20 seconds.
• R/S Time Base: This is the time base for the Ramp Soak profiles
and is only available in the RS and CP versions. The range may be
in 999 hour:59 minute or 999 minute:59 second. It applies to all the
r/s profiles and all loops in r/s.