Watlow ANASOFT - Manual (Page 30)

20 ANASOFT User’s Guide
Start Up
NOTE
See the respective controller hardware manual for
assistance in checking the communication parameters
and verifying the communication wiring.
• If there is more than one controller in the system, ANASOFT will
try supervising those controllers which are operating and communi-
cating correctly. After start up ANASOFT periodically re-checks
communications to the failed controller.
• By continuing the start up, the controllers not communicating will
be listed by address on the System Errors window in the System
Setup screen. Check the controllers listed on the screen. Be sure the
address is correct as set on the controllers.
EPROM version error
If 8LS, 12LS, MLS, or CLS controllers are in the system, ANASOFT
checks the controller EPROM version at start up and verifies that it’s
acceptable to the version of ANASOFT. The following message may
appear:
.
Message Cause Solution
Unacceptable
controller
EPROM version The EPROM version is
not acceptable to the
version of ANASOFT. Contact Watlow-Anafaze to obtain
EPROM upgrade