Watlow ANASOFT - Manual (Page 32)

22 ANASOFT User’s Guide
General Screen
• Type the new desired value into the new value box.
• Press Enter. The new value will be displayed over the original one,
and will be downloaded to the controller. If you made a mistake in
entering the value and have not pressed Enter yet, use the back-
space key to correct.
• Use the F4 Key to enter the Job Setup screen and save the changes.
If you don’t, upon a new start up, the Job data file will be read from
the disk along with the old parameter.
NOTE
The new value is sent first to the respective controller.
The display changes only after the controller accepts
the new value. This may cause a slight delay after
entry, especially on slow computers or when a large
number of controllers is connected.
Print Screen
• You can print all ANASOFT screens on an IBM graphics compati-
ble dot matrix printer.
• Use the PRTSC key. When the print screen is initiated, the copy of
the current screen is transferred to a buffer and the screen will be
printed as a background task. The program continues operating and
you can display other screens while printing a screen.
• When printing the Trend Plot screen, you will be asked for a title
before printing the screen.