Watlow ANASOFT - Manual (Page 16)

6 ANASOFT User’s Guide
Installation
STATUS.DAT - system start up status file
DIGIO.DAT - digital I/O screen data
DLOG.DAT - data logging data file
GRPINFO.DAT - group set up data file
HDR.WK1 - Lotus header set up file
PLOT.DAT - plot parameters data file
The following list contains files created from the software:
XXXXXXXX.J## - group job directory data file
NEWXX.PLT - plot files which were created within the last 24 hours.
OLDXX.PLT - older plot files
PXXXXXXX.TXT or WK1 process logging files
AXXXXXXX.TXT or WK1 alarm logging files
ANASOFT-RS also includes:
XXXXXXXX.R## - R/S program assigned data file
XXXXXXXX.PRF - R/S program data file
WARNING
Make copies of disks before running the program,
and store the original ANASOFT disks in a safe
place. Use the copies to operate the system.
File Locations
360k dual floppy disk system:
Watlow-Anafaze recommends that you store the ANASOFT operating
program file and the INSTAL.DAT file on drive A, and all other files on
drive B. Once the program ANAINSTL is run, you can remove
ANAINSTL.EXE from drive B to allow more room for data. Do not
remove files from the master disk.
720k or higher floppy disk system:
Watlow-Anafaze recommends that you store all files of the ANASOFT
operating program on one drive such as A. Use the B drive to store all
recording data by setting up directories as shown in the hard disk
systems recommendations.