Watlow ANASOFT - Manual (Page 53)

System Setup
ANASOFT User’s Guide 43
When you choose Download Profile or Upload Profile, you will be
asked for a job’s name. This can be either a specific job or the last job
running when ANASOFT was terminated.
Normal start up action
This is the start up action when the program starts up normally.
Power failure recovery
When the program starts up following a power failure, it determines the
time between the power failure and the start up. If the time is less than
the power failure recovery time limit, the program takes the under limit
start up action. If the time is greater than the power failure recovery time
limit, the program takes the over limit start up action. The time limit is
entered in hours and minutes.
NOTE
In order for the power failure recovery sequence to
operate, ANASOFT must be started automatically
when the computer is powered up. This is done using
an AUTOEXEC.BAT file which contains commands
which the computer executes at power up. See DOS
o p e r a t i n g m a n u a l f o r d e s c r i p t i o n o f
AUTOEXEC.BAT files. The file should contain as its
last commands:
1) a command to enter the disk directory containing
ANASOFT.
2) a command to stated executing the ANASOFT pro-
gram.
When recording data to floppy disk, use only the B
drive.