Watlow ANASOFT - Manual (Page 37)

Edit
ANASOFT User’s Guide 27
Edit
The Edit screen enables you to change these three parameters in the
single loop display you have selected:
1. loop’s setpoint
2. Manual or Automatic control operation
3. Percent control output (only in Manual control).
The Edit screen uses the same format as the Overview screen, only here
you can move the cursor to change the values. This screen is not
password protected.
The Edit screen performs nearly the same functions as the change
setpoint and manual/auto keys on the 8LS, 12LS, MLS, or CLS
controllers front panel.
Getting Here
Press F1 from the Overview screen. You will enter an Edit screen with
the same display as the screen you were in before pressing F1. The
screen below is an Edit screen for the 16 loop display.