IEI Integration AFL2-10A-N28 - Manual (Page 35)

AFL2-10A-N28 Panel PC
Page 18
3.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the maintenance of the
AFL2-10A-N28 may result in permanent damage to the AFL2-10A-N28
and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the AFL2-10A-N28. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the AFL2-10A-N28 is accessed internally, or any other
electrical component is handled, the following anti-static precautions are strictly adhered
to.
ƒ Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
ƒ Self-grounding: - Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
ƒ Use an anti-static pad: - When configuring the AFL2-10A-N28, place it on an
antic-static pad. This reduces the possibility of ESD damaging the
AFL2-10A-N28.
ƒ Only handle the edges of the PCB: - When handling the PCB, hold the PCB
by the edges.
3.2 Installation Precautions
When installing the flat bezel panel PC, please follow the precautions listed below:
ƒ Power turned off: When installing the flat bezel panel PC, make sure the
power is off. Failing to turn off the power may cause severe injury to the body
and/or damage to the system.
ƒ Certified Engineers: Only certified engineers should install and modify
onboard functionalities.