IEI Integration IMB-Q354 v1.10 - Manual (Page 59)

IMB-Q354 microATX Motherboard
Page 59
4.3 Unpacking
4.3.1 Unpacking Precautions
When the IMB-Q354 is unpacked, please do the following:
Follow the anti-static precautions outlined in Section 4.1.
Make sure the packing box is facing upwards so the IMB-Q354 does not fall
out of the box.
Make sure all the components in the checklist shown in Chapter 2 are
present.
NOTE:
If some of the components listed in the checklist in Chapter 2 are
missing, please do not proceed with the installation. Contact the IEI
reseller or vendor you purchased the IMB-Q354 from or contact an IEI
sales representative directly. To contact an IEI sales representative,
please send an email to [email protected].
4.4 CPU, CPU Cooling Kit and DIMM Installation
WARNING:
A CPU should never be turned on without the specified cooling kit
being installed. If the cooling kit (heat sink and fan) is not properly
installed and the system turned on, permanent damage to the CPU,
IMB-Q354 and other electronic components attached to the system
may be incurred. Running a CPU without a cooling kit may also result
in injury to the user.
The CPU, CPU cooling kit and DIMM are the most critical components of the IMB-Q354. If
one of these components is not installed the IMB-Q354 cannot run.