3 lan connection, Figure 4-14: dvi connector – IEI Integration KINO-AH612 User Manual

Page 64

KINO-AH612

Page 53

Step 2:

Align the DVI-I connector. Align the male DVI-I connector on the digital display

device cable with the female DVI-I connector on the external peripheral

interface.

Step 3:

Insert the DVI-I connector

Once the connectors are properly aligned with the

male connector, insert the male connector from the digital display device into the

female connector on the KINO-AH612. See Figure 4-14.

Figure 4-14: DVI Connector

Step 4:

Secure the connector. Secure the DVI-I connector from the digital display

device to the external interface by tightening the two retention screws on either

side of the connector.

Step 0:

4.6.3 LAN Connection

There are two external RJ-45 LAN connectors. The RJ-45 connector enables connection

to an external network. To connect a LAN cable with an RJ-45 connector, please follow

the instructions below.

Step 1:

Locate the RJ-45 connectors. The location of the LAN connectors is shown in