3 dimm installation, Figure 4-7: dimm installation – IEI Integration KINO-AH612 User Manual

Page 57

KINO-AH612

Page 46

Step 4:

Secure the cooling kit by fastening the four retention screw of the cooling kit.

Step 5:

Connect the fan cable. Connect the cooling kit fan cable to the fan connector

on the KINO-AH612. Carefully route the cable and avoid heat generating chips

and fan blades.

4.3.3 DIMM Installation

To install a DIMM, please follow the steps below and refer to Figure 4-7.

Figure 4-7: DIMM Installation

Step 1:

Open the DIMM socket handles. Open the two handles outwards as far as they

Step 2:

Align the DIMM with the socket. Align the DIMM so the notch on the memory

lines up with the notch on the memory socket. See Figure 4-7.

Step 3:

Insert the DIMM. Once aligned, press down until the DIMM is properly seated.

Clip the two handles into place. See Figure 4-7.

Step 4:

Remove a DIMM. To remove a DIMM, push both handles outwards. The

memory module is ejected by a mechanism in the socket.