IEI Integration KINO-AH612 - Manual (Page 60)

KINO-AH612
Page 49
ƒ Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in Table 4-3.
Setting Description
Short 1-2 Normal Operation Default
Short 2-3 Clear CMOS Setup
Table 4-3: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in Figure 4-10.
Figure 4-10: Clear CMOS Jumper Location
4.5 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the on-board connectors
4.5.1 SATA Drive Connection
The KINO-AH612 is shipped with two SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-11.