IEI Integration KINO-945GSE2 - Manual (Page 62)

KINO-945GSE2 Motherboard
Page 50
Before and during the installation of the KINO-945GSE2 DO NOT:
DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
DO NOT use the product before verifying all the cables and power connectors
are properly connected.
DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
4.3 Unpacking
When the KINO-945GSE2 is unpacked, please check all the unpacking list items listed in
Chapter 2 are indeed present. If any of the unpacking list items are not available please
contact the KINO-945GSE2 vendor reseller/vendor where the KINO-945GSE2 was
purchased or contact an IEI sales representative.
4.4 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the KINO-945GSE2. Please make sure the purchased SO-DIMM
complies with the memory specifications of the KINO-945GSE2.
SO-DIMM specifications compliant with the KINO-945GSE2 are listed
in Chapter 1.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below and refer to
Figure 4-1.