Teledyne LeCroy IBTrainer - IBTrainer Users Manual - Manual (Page 93)

Test Description Using the InfiniBand Compliance Test Suite
CATC IBTrainer InfiniBand Exerciser, August 2002
93
Basic Directed Route SMP Response
TD_17.1.2.1.1
Item Value
Name TD_17.1.2.1.1
Description The test is used to ensure that the DUT correctly re-
sponds to a direct route SMP.
Topology Simple
Initial link state Active
Assertions v1c14-009#02.07 v1c14-010#01 v1c14-010#02
v1c14-010#03 v1c14-011#04.02 v1c14-010#04
v1c14-011#03 v1c14-008#01 v1c14-009#02.01
Prerequisites None
Test procedure Sending a SubnDirectGet(NodeInfo) SMP, the following
tests are performed:
1 Check if there is a reponse.
2 Check if the 'Status' does not indicate problems.
3 Check if the direction bit is 1.
4 Check if the following values in the request packet and
the response packet are equal: MgmtClass, HopCount,
DrSLID, DrDLID, InitialPath.
5 Check if HopPointer and HopCount are equal in
response packet.
6 Check if 'BaseVersion' and 'ClassVersion' are equal 1
in response packet.
7 Compare if 'TransactionID' and 'AttributeID' are equal
in request and response packet.
8 In response packet, compare VL to 15, LVer to 0, SL to
0, Resv12 to 0, LNH with 2, Resv32 to 0, PktLen with
expected packet length, OpCode with 'UD Send Only',
PadCnt to 0, TVer with 0
9 Verify correct position of the DUTs LocalPortNum in
the ReturnPath.