Teledyne LeCroy IBTrainer - IBTrainer Users Manual - Manual (Page 62)

Using Auxiliary Features Sending TCL Commands to the IBTrainer
62
CATC IBTrainer InfiniBand Exerciser, August 2002
How to Launch a Performance
Measurement
To launch a performance measurement:
1 Select Tools>Show Performance Measurements.
2 Click the tab corresponding to the counter that you want to use.
3 Select the check boxes corresponding to the virtual lanes to be
monitored for the outgoing (TX) and incoming (RX) packets.
4 Click the Run button to start the measurement.
During the measurement, the packet information is monitored and
displayed in runtime. In the Totals tab, the two counters can be
compared.
Sending TCL Commands to the
IBTrainer
The release 8.3.4 of the TCL (Tool Command Language) language is
installed with the software. The software allows you to send single TCL
commands to the IBTrainer through the installed TCL console.
To open the TCL console, select Tools>Debug>Console Window, and
enter the command that you want to send.
Refer to http://tcl.activestate.com/scripting for more information about
the TCL language.