Teledyne LeCroy IBTrainer - IBTrainer Users Manual - Manual (Page 22)

Overview of the IBTrainer Description of the Hardware
22
CATC IBTrainer InfiniBand Exerciser, August 2002
W A R N I N G • Do not open the unit. There are no operator serviceable parts inside.
For servicing contact your CATC representative.
• To prevent the influence of ESD on measurements, all tests must be
performed in an ESD-protected environment.
Installation and Maintenance
Initial Inspection Inspect the shipping container for damage. If the container or cushioning
material is damaged, keep it until the contents of the shipment have been
checked for completeness and the instrument has been verified both
mechanically and electrically.
W A R N I N G To avoid hazardous electric shock, do not perform electrical tests when
there are signs of shipping damage to any part of the instrument's outer
covers or panels.
If the contents are incomplete, or there is mechanical damage, or if the
instrument does not work as expected within its specifications, notify
the nearest CATC office.
Power Requirements The instrument can operate from any single-phase AC power source
supplying 100 – 240 V in the frequency range from 50 – 60 Hz. The
maximum power consumption is 100 VA with all options installed. When
the instrument is switched on the power supply adapts automatically to
the applied AC power (Auto Selection) and monitors the AC power range
during operation.
Ventilation Requirements Make sure that there is adequate clearance of 30 mm at the left and the
right side to ensure adequate air flow. If the air flow is restricted, the
internal operating temperature will be higher, reducing the instrument's
reliability.
N O T E Do not cover the ventilation holes.
Cleaning Recommendation Use a dry cloth or one slightly dampened with water to clean external
case parts. Do not attempt to clean internally.
W A R N I N G To prevent electrical shock, disconnect the instrument from mains
before cleaning.