Teledyne LeCroy IBTrainer - IBTrainer Users Manual - Manual (Page 3)

CATC IBTrainer InfiniBand Exerciser, August 2002
3
Safety Information
The following general safety precautions must be observed during all
phases of operation of this instrument. Failure to comply with these
precautions or with specific warnings elsewhere in this manual
violates safety standards of design, manufacture, and intended use of
the instrument.
CATC assumes no liability for the customer's failure to comply with
these requirements.
Before operation, review the instrument and manual for safety
markings and instructions. You must follow these to ensure safe
operation and to maintain the instrument in safe condition.
Safety Summary This product is a Safety Class 1 instrument (provided with a protective
earth terminal). The protective features of this product may be
impaired if it is used in a manner not specified in the operation
instructions.
All Light Emitting Diodes (LEDs) used in this product are Class 1
LEDs as per IEC 60825-1.
Environmental conditions This instrument is intended for indoor use in an installation category
II, pollution degree 2 environment. It is designed to operate at a
maximum relative humidity of 95% and at altitudes of up to 2000
meters.
Refer to the specifications tables for the ac mains voltage
requirements and ambient operating temperature range.
Before applying power Verify that the product is set to match the available line voltage, the
correct fuse is installed, and all safety precautions are taken.
Ground the instrument To minimize shock hazard, the instrument chassis and cover must be
connected to an electrical protective earth ground. The instrument
must be connected to the ac power mains through a grounded power
cable, with the ground wire firmly connected to an electrical ground
(safety ground) at the power outlet. Any interruption of the protective
(grounding) conductor or disconnection of the protective earth
terminal will cause a potential shock hazard that could result in
personal injury.
Do not operate in an explosive
atmosphere
Do not operate the instrument in the presence of flammable gases or
fumes.