Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 - Manual (Page 42)

Teledyne LeCroy Software Menus and Toolbar
40 SierraNet M408 User Manual
Data View icon. See “Data View” on page 46.
Export to Wireshark icon. Click to export trace to Wireshark and
launch the Wireshark application. Wireshark must be installed
on the PC. Wireshark is a free application available at
www.wireshark.org. (see
“Export and Open with Wireshark” on
page 42 ).
Displays the Trace information dialog. (see “Trace Information”
on page 47 ).
Find icon. You can search for specific Triggers and specify the
From, Domain, Direction and Logic. See
“Find” on page 179.
Find Next icon. Searches for the next instance.
Find Previous icon. Searches for the previous instance.
Go to icon. Click to locate cursors or specific packets: Timestamp,
X Position, Y Position, Event, Begin, and End. See
Figure 2.17 on
page 50 .
Go to Trigger icon. Click to go to the trigger point in the trace.
See
Figure 2.17 on page 50 .
Go to Marker icon. Click to go to a specific Marker. See “Markers”
on page 162 .
Zoom in icon. Searches for the previous instance.
Zoom out icon. Searches for the previous instance.
Filter icon. Click to open the filter dialog. See “Filtering” on
page 173 .
Ports icon. Click to select a port. See “Ports” on page 169 .
Idles icon. Click to show/hide idles in a trace.
External Trigger Setting icon. Click to open the Device Settings
dialog. See
“External Trigger” on page 88 .
Recording Setting icon. Click to open the Recording Setting
dialog. See
“Recording Settings Pane” on page 55 .
Trigger Filter Settings icon. Click to open the Trigger Filter
Settings dialog. See
“Patterns and Data Capture Setup” on
page 67 .