Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 - Manual (Page 179)

SierraNet M408 User Manual 177
Using Cursors Teledyne LeCroy
Figure 3.36: LUN and LBA Filter
3.4 Using Cursors
3.4.1 Cursors
The spreadsheet view display incorporates three cursors labeled X, Y, and T. All cursors
are initially overlaid and positioned at location 0, which is the trigger position of the
display. The Trigger, or T, cursor is the measurement reference and is always at location 0
in the display.
Positioning the X Cursor
To position the X‐Cursor within the viewer data display, click the left mouse button in the
gray bar on the left side of the trace viewer next to the line in which to place the cursor.
Positioning the Y Cursor
To position the Y‐cursor within the viewer data display, click the right mouse button in the
gray bar on the left side of the trace viewer next to the line in which to place the cursor.
Locate Cursors
To quickly locate any cursor within the data viewer display, right‐click and select the Go To
X or Go To Y option and choose the cursor to locate (see
Figure 3.37 on page 178 ). You
can also locate a cursor by selecting Go To from the Navigation menu and choosing the
cursor to locate.