Ipmode dynamic – Teledyne LeCroy SierraNet M408 User Manual Ver.1.50 User Manual
Page 15
SierraNet M408 User Manual
13
Analyzer Overview
Teledyne LeCroy
Set IP Mode Static is displayed in the LCD display. If you do not want to set IP Mode
Static, press the Up Button to set the IP Mode Dynamic, see
3. Press the Center Button once to select Set IP Mode Static.
The Static IP address (for example: 188.168.040.036) is displayed in the LCD display.
4. Press the Center Button once to set the Static IP address.
The first numeral of the IP address will start blinking.
5. Use the Up Button or Down Button to change the IP Address.
6. Press the Right Button or Left Button to move to the right or left to change each
component of the static or dynamic IP address and change it using step 5.
7. Once the IP Address is set, press the center button to select it.
8. Press the Up Button once to Accept and Reboot.
9. Press the Up Button once to Cancel the Changes.
10. Press the Up Button once to set the Gateway address. Repeat steps 4 through 9 to
set the Gateway address.
11. Press the Up Button once to set the Subnet Mask address. Repeat steps 4 through 9
to set the Subnet Mask address.
12. Press the Up Button once to set the Static IP address. Repeat steps 4 through 9 to
set the Static IP address.
13. Press the Center Button once to confirm reboot. The LCD display will read Center
Button to Confirm Reboot.
14. The Analyzer will reboot. The LCD display will display the new IP Configuration.
IPMode Dynamic
Perform the following steps to set IP Mode Dynamic on the Analyzer:
1. Press the Up Button once to get into the Set IP Configuration mode.
2. Press the Center Button once to select Set IP Configuration.
Set IP Mode Dynamic is displayed in the LCD display.
3. Press the Center Button once to select Set IP Mode Dynamic.
The Dynamic IP address (for example: 188.168.040.036) is displayed in the LCD
display.
4. Press the Center Button to select it.
5. Press the Up Button once to Accept and Reboot.
6. Press the Up Button once to Cancel the Changes.
Note:
In case the device is often moved from one subnet to the other, it is recommended to configure
the DHCP server so that the device always receives the same (known) IP address. Many DHCP
server allow this type of static allocation based on the devices MAC address.