Teledyne LeCroy LogicStudio User Manual
Page 36
LogicStudio
A
32
922294 Rev A
During subsequent program startups, LogicStudio remembers and, if
available, auto-connects to the last connected devices.
NOTE
: Before you can perform mixed signal acquisitions (analog and digital)
using LogicStudio, ensure a proper oscilloscope/PC USB connection and
make sure the Trig Out line from LogicStudio16 is connected to the
external trigger input on your oscilloscope using with the BNC cable
provided with your LogicStudio16.
A proper connection configuration diagram is provided during setup in the
Device Finder window.
Oscilloscope Models Supported by LogicStudio
T
ELEDYNE
L
E
C
ROY
Support for Teledyne LeCroy WaveJet 300A Series oscilloscopes is included
with the LogicStudio installation. No additional software is needed.
Support for Teledyne LeCroy WaveAce oscilloscopes requires a VISA
implementation installed on the PC you’re using. The following WaveAce
oscilloscopes are supported:
WaveAce 1000 Series
WaveAce 2000 Series
NOTE: When using WaveAce oscilloscopes, ensure the Back USB setting on
the instrument is set to USBTMC. This setting is made pressing the Utility
button on the oscilloscope and going to Page 2.
A
GILENT
Support for Agilent oscilloscopes requires a VISA implementation installed
on the PC you’re using. Agilent IOLibSuite software includes their VISA
implementation and can be obtained from the software included with the
oscilloscope or from the Agilent website
following
oscilloscopes are supported:
DSO5000A Series
DSO6000A Series
DSO7000A and 7000B Series