Teledyne LeCroy LogicStudio - Manual (Page 21)

Getting Started Manual
B
922294 Rev A 17
Run Modes
Four run mode buttons are available on the upper-right of the dashboard
as follows:
The modes Auto, Normal, Single, and Stop behave similarly to an
oscilloscope.

Stop prevents any new acquisitions.

Single mode attempts to get exactly one new acquisition, while
Normal gets repeated acquisitions.

Auto mode is similar to normal except it times out and forces a
trigger if the current trigger condition hasn’t been met within a
specified period of time.
The Run Mode section of the dashboard also contains two green indicators
for Ready and Triggered. These indicators reflect the state of the digital
device at any point in time.
Persistence
Directly above the run mode buttons on the dashboard are the Persistence
controls. Click the Persist button to toggle the function on/off. When
persistence is on, subsequent acquisitions are received and shown on the
waveform display. Use the Clear button to remove the waveforms from the
display and restart your acquisitions.
NOTE : The Clear button also clears your RearView™ history.
Status Display
At times an animated status display appears in the upper-right corner of
the dashboard (above the Persistence and Clear controls). This display
provides messages when certain device actions are taking a longer period
of time.
For example, the Status Display indicates when the software is waiting for