IAI America PDR-101-MW - Manual (Page 5)

z Be sure to use genuine parts supplied by IAI for the cable between the actuator and controller. Moreover,
be sure to use genuine parts supplied by IAI for each component, such as an actuator, controller or
teaching pendant.
z Post a display, for instance “Work in Progress: Do not turn on the power,” when performing tasks relating
to installation, adjustment, etc., so that the power is not turned on inadvertently. If the power is turned on
inadvertently, there is a risk of electric shock or injury due to sudden activation of the actuator.
z
Turn on the power to the host device first. Failure to do so may lead to injury or product damage, since
the product may be activated suddenly.
z Do not place fingers or objects in any of the opening parts of this product. Doing so may lead to fire,
electric shock and injury.
z Do not place floppy disks or other magnetic media within one meter of this product. Data stored on the
floppy disks may be damaged by the strong magnetic field caused by the magnet within this product.
z
Do not touch the terminals when conducting the insulation-resistance test. Doing so may cause electric
shock. (Do not conduct the withstand voltage test on a product that uses a DC power supply.)
Note
z
Be duly cautious in use by providing a sufficient margin to the stated rating and performance limitations,
as well as safety measures (for instance, failsafe measures), if you are considering using the product
under conditions or in environments not described in the catalog and operation manual. This also
applies if you are considering using the product for applications requiring special security such as air
navigation facilities, combustion equipment, entertainment devices, cleanrooms, security devices or
other situations where significant influence on the safety of human life and properties can be expected.
Be sure to consult our sales representative.
z
Do not place obstacles that prevent ventilation near the controller. Doing so may damage the controller.
z Do not configure control loops that may cause workpieces to be dropped in case of a power failure.
Configure the control loops so that tables and workpieces can be prevented from dropping in case of
power failure and/or the emergency stop of machinery.
z
When handing this product, wear protective gloves, safety glasses, protective footwear, etc., as
necessary to secure safety.
z
If this product becomes unusable or no longer necessary, dispose of it properly as industrial waste.
Others
Q IAI shall have no liability if the general precautions in “Directions for Safe Use” are not
observed.
Q For inquires about this product, please contact your local sales office. Addresses and
telephone numbers of sales offices are listed at the end of the operation manual.
Operation
Maintenance, Inspection and Service
General
Installation
Installation, Operation and Maintenance
Disposal