Reese 37152 MULTI-FIT RECEIVER - Manual (Page 13)

INSTALLATION K
TOOLS REQUIRED
19MM SOCKET
3/4” SOCKET
1/2” DRILL
TORQUE WRENCH
SAFETY GLASSES
USE THIS HOLE
FOR CENTER
SECTION ASSEMBLY
1/2 x 2” CARRIAGE BOLT
1/2” FLAT WASHER
1/2” LOCK WASHER
12MM HEX NUT
1/4” BOLT PLATE
EXISTING STUDS IN FRAME
VEHICLE FRAME
DRILLED HOLE
HOLE #1
HOLE #2
HOLE #3
1/2” FLAT WASHER
1/2” LOCK WASHER
1/2” HEX NUT
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly (page 2-3); tighten all fasteners to proper specifications (page 1)
93-98 JEEP GRAND CHEROKEE
1. Place the side brackets over the studs that are fastened into the bottom of the frame. Use holes 2 & 3.
Install 1/2" flat washers, lock washers, and 12mm nuts on the studs.
2. Drill a 1/2" hole into the frame using hole 1 as a guide. Thread 1/2 x 2 carriage bolt onto the pull wire
and place a 1/4 bolt plate over the bolt. Insert the free end of the pull wire into the top of the bumper
bracket. This is between the end of the frame and the bumper. Push it out through hole 1. Pull the bolt
down through the hole. Unscrew the pull wire. Install 1/2" flat washers, lock washers, and nuts on the
carriage bolts.
3. Install center section per SIDE BRACKET LOCATION 1. (See page 2)
REFER TO SIDE BRACKET LOCATION INSTRUCTIONS FOR PROPER BOLT TIGHTENING SEQUENCE