Reese 37051 MULTI-FIT RECEIVER - Manual

INSTALLATION INSTRUCTIONS
Product No.
37051
TOOLS REQUIRED
1/2" DRILL BIT
3/4" SOCKET
3/4" WRENCH
TORQUE WRENCH
SAFETY GLASSES
SMALL PARTS
PACKAGE 37628
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO EXCESSIVE TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH. IMPORTANT NOTES
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH
1. Spare tire will need to be loosened for hitch installation.
2. Using the 1/2 " x 1 1/4 " bolts, 1/2 " lock washers, and 1/2 " nuts install the frame straps to the hitch brackets. Leave the bolts loose.
3. Mount hitch to the frame using the bolt plates as spacers between the frame and the hitch. Install 1/2 " x 1 3/4 " bolts, flat washers,
lock washers, and nuts. Bolt through the existing holes in the side of the frame.
4. Using the hole in the flange as a guide, drill 1/2 " holes through the bottom of the frame. Install 1/2 " bolt through bolt plate and
insert through the frame and install 1/2 " flat washer, lock washer, and nut.
5. Torque 1/2 " nuts to 70 ft•lb.
6. Retighten the spare tire.
’95-’97 BLAZER, ‘ 95- ‘ 97 JIMMY, AND ‘ 96- ‘ 97 BRAVADA
1/2" X 1 3/4 " BOLT
1/2" FLAT WASHER
1/2" LOCK WASHER
1/2" FLAT WASHER
1/2" NUT
BOLT PLATE
FRONT
REAR
MULTI - FIT
BOLT PLATE
1/2" X 1 3/4 " BOLT
1/2" LOCK WASHER
1/2” NUT
1/2" X 1 1/4 " BOLT
1/2” LOCK WASHER
1/2” NUT
FRAME STRAP
FLANGE
You can take it with you.
PLYMOUTH, MICHIGAN
For Installation Assistance or Technical Help, See our Web Site at
www.reeseprod.com or Call 1-800-428-7303
37051IN REV_D 04-11-06 PCN8675 © 2006 CEQUENT TOWING PRODUCTS Litho in USA