Reese 37034 MULTI-FIT RECEIVER User Manual

Installation instructions, Multi-fit pick-up, Product no

INSTALLATION INSTRUCTIONS

Product No.

37034

TOOLS REQUIRED

5/8”

DRILL BIT

15/16”

SOCKET

15/16”

WRENCH

3/4”

SOCKET

3/4”

WRENCH

CLAMPS

TORQUE WRENCH

You can take it with you.

SMALL PARTS

PACKAGE 37424

PLYMOUTH, MICH.

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

IMPORTANT NOTES

USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH

MULTI-FIT PICK-UP

RIVET IN FRAME

5/8” BOLT

1/4 BOLT PLATE

3/8” SPACER

5/8” LOCK WASHER

5/8” NUT

1/2” BOLT

1/2” LOCK WASHER

1/2” NUT

FRAME

FRONT

REAR

1973-1996 Ford Full Size Pickup & 1997 F-250 Heavy Duty / F-350 Heavy Duty:

1. Assemble the three pieces of the hitch together on the floor before attaching it to the truck. Using 1/2” bolts, lock washers and nuts, bolt the

brackets to the center section as shown. Place the brackets on the outside of the center section. Bolt through the holes shown in the
illustration. Leave the bolts loose enough to center brackets on truck frame. NOTE: Be sure to use four holes to bolt each bracket to the center
section.

2. Clamp the hitch to the frame with a 3/8” thick spacer between the hitch and the frame at the rear. Align the ends of the brackets with the end

of the frame as shown.

3. Using the holes in the bracket as a guide, drill 5/8” diameter holes into the frame at the locations shown.
4. Insert 5/8” bolts with bolt plates down through the frame and into the bracket. Place a 3/8” thick spacer between the frame and the bracket at

the rear mounting hole. Install a 3/8" thick spacer, lock washer and nut on each bolt.

5. Tighten the nuts in the following order: First torque the 1/2" nuts to 70 ft•lb. Then torque the 5/8" nuts to 115 ft•lb.

NOTE: SIDE BRACKETS WILL DEFLECT WHEN TIGHTENED

3/8” SPACER

For Installation Assistance or Technical Help, See our Web Site at