Reese 45009 TITAN RECEIVER - Manual

INSTALLATION INSTRUCTIONS
Product No.
45009
You can take it with you.
SMALL PARTS
PACKAGE 45261
ELKHART, IN., OAKVILLE, ONT.
CHEVY & GMC
PICKUP
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH. IMPORTANT NOTES
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH
1 /2 " CARRIAGE BOLT
B OLT PLATE
1 /2" FLAT WASHER
1 /2" LOCK WASHER
1 /2" NUT
EXIS TING 14MM BOLT
TOOLS REQUIRED
3/4” SOCKET
21MM SOCKET
TORQUE WRENCH
(OVER)
1. Remove the 14mm bolt from the bottom of bumper bracket on both sides of the vehicle. Align the hitch with these holes and
re-install the two existing 14mm bolts.
2. Insert 1/2” carriage bolts through bolt plates and down through the remaining holes in the frame and install 1/2” flat washer,
1/2” lock washer, and 1/2” nut. Hand tighten all nuts.
3. Torque all 14mm bolts to 85 ft*lb.
Torque all 1/2” nuts to 70 ft*lb.
For Installation Assistance or Technical Help, Call 1-800-758-0869
45009IN-1JAN99A PCN4283 © 1998 REESE PRODUCTS, INC. Litho in USA