Reese 37053 PREMIUM RECEIVER - Manual

INSTALLATION INSTRUCTIONS
Product No.
37053
You can take it with you.
SMALL PARTS
PACKAGE 1000000010
ELKHART, IN., OAKVILLE, ONT.
JEEP LIBERTY
TOOLS REQUIRED
9/16” SOCKET
18MM SOCKET
19MM SOCKET
TORQUE WRENCH
WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH. IMPORTANT NOTES
USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH
EXISTING WELDNUTS IN
VEHICLE FRAME 3 PER SIDE
VEHICLE FRAME RAIL
FUEL TANK SHIELD
1/2” STRUCTURAL WASHER
1/2” LOCK WASHER
12MM 1.75 X 40MM HEX BOLT
3/8” RIBBED NECK BOLT
3/8” LOCK WASHER
3/8” HEX NUT
1. IF VEHICLE IS EQUIPTED WITH A FUEL TANK SHIELD, REMOVE THREE (3) ON DRIVERS SIDE AND ATTACH FRAME
BRACKET USING SUPPLIED 12MM BOLTS WITH 1/2” LOCK WASHERS AND 1/2” STRUCTURAL WASHERS INTO
EXISTING WELD NUTS IN VEHICLE FRAME. REPEAT FOR PASSENGER SIDE, LEAVING HARDWARE LOOSE. DISCARD
HARDWARE THAT WAS REMOVED.
FRAME
BRACKET
HITCH
CENTER SECTION
WITH FUEL
TANK SHIELD
(OVER)
For Installation Assistance or Technical Help, See our Web Site at
www.reeseprod.com or Call 1-219-266-3993
37053IN-1SEP01A PCN5682 © 2001 REESE PRODUCTS, INC. Litho in USA