Reese 45010 TITAN RECEIVER User Manual

Installation instructions, Dodge truck, Product no

INSTALLATION INSTRUCTIONS

Product No.

45010

You can take it with you.

SMALL PARTS

PACKAGE 45266

ELKHART, IN., OAKVILLE, ONT.

DODGE TRUCK

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

IMPORTANT NOTES

USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH

TOOLS REQUIRED

3/4” SOCKET
1/2” DRILL
TORQUE WRENCH

For Installation Assistance or Technical Help, Call 1-800-758-0869

1.Insert 1/2”carriage bolts with bolt plates down through the 1/2” holes at the end of the frame. On some models there are two holes at

the end of the frame. Use the smaller hole forward of the large hole.

2.Hold the hitch up under the frame with the bolts going through the holes in the brackets. Install 1/2” serrated washers, 1/2” lock

washers, and 1/2” nuts on the bolts. See diagram above.

3. Insert 1/2” carriage bolts with bolt plates down through the remaining holes. Install 1/2” serrated washers, lock washers, and 1/2”

nuts on the bolts. See diagram above. Some short bed models will need to have the front hole drilled. Use the hole in the bracket as
a guide to drill the hole.

4.Torque all 1/2” nuts to 70 ft.*lbs.

1/2” BOLT

1/2” SERRATED WASHER

1/2” LOCK WASHER

1/2” NUT

BOLT PLATE

(OVER)