Reese 36025 PREMIUM RECEIVER User Manual

Installation instructions, Ford and dodge pickup trucks, Product no

INSTALLATION INSTRUCTIONS

Product No.

36025

You can take it with you.

SMALL PARTS PACKAGE 36556

ELKHART, IN., OAKVILLE, ONT.

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY
OCCUR DUE TO OVER TIGHTENING.
WARNING: DO NOT DRILL OR WELD TO THIS HITCH.

IMPORTANT NOTES

USE ONLY REESE SUPPLIED OR APPROVED BOLTS, LOCKNUTS,
AND WASHERS TO INSTALL THIS HITCH

FORD AND DODGE

PICKUP TRUCKS

TOOLS REQUIRED

3/4" WRENCH
3/4" SOCKET
1/2" DRILL
100 LB-FT TORQUE WRENCH

1/2" CARRIAGE BOLT
1/2" FLAT WASHER

1/2" FLAT WASHER

1/2" LOCK WASHER

1/2" NUT

1/2" HEX BOLT

1/2" FLAT WASHER

HALF HOLE SPACER

LARGE SPACER

FORD

DODGE

CAUTION: When drilling holes in the frame, make sure that electrical wires are not damaged. If necessary, move them before drilling.

WARNING: HYDRAULIC BRAKE HOSES MUST NOT TOUCH THE SPARE TIRE. Some 'oversize' tires are too large and will not have safe
clearance with brake hoses. These tires must be mounted elsewhere.

1. Loosen or remove spare tire assembly.

FORD PICKUP EXCEPT FLARESIDE WITH ROLLED PAN
2. Clamp the hitch to the frame with the large holes over the rivet heads. Match drill six 1/2" holes in the frame flange.
3. Insert four 1/2" carriage bolts with bolt plates down through the front holes. Install flat washers, lock washers, and nuts on the bolts.
4. Insert two 1/2" bolts with flat washers and half hole spacers through the rear holes. Spacers level the washers on the crossmember.

Install flat washers, lock washers, and nuts. Go to step 5.

DODGE
2. Insert two 1/2" bolts with large spacers through the large holes (1-1/4") near the rear of the frame. Position the hitch on the bolts and

loosely install flat washers, lock washers, and nuts on the bolts.

(OVER)

Litho in USA