Ransburg Evolver 303 Solvent Applicator A11976-XXX - Manual (Page 18)

INSTALLATION
EVOLVER 303 ROBOTIC
ATOMIZER
INSTALLATION
This information is intended ONLY to indicate the
general installation parameters of this product and,
where applicable, its working relationship to other
Ransburg system components in typical use. Each
installation is unique and should be directed by an
authorized Ransburg representative or conducted
from the Ransburg installation drawings provided
for your particular installation.
POWER SUPPLY
ASSEMBLY
Refer to the most current Power Supply Unit
manuals for complete information regarding power
supply installation.
• MicroPak Control Unit (LECU5004)
(for non-FM installations)
• Stand-alone control/power supply unit
(A10406) (for FM installations)
• MicroPak Control Unit (LECU5004-31)
(for FM installations)
MOUNTING
The Evolver 303 is equipped with a quick dis-
connect assembly. The quick disconnect feature
consists of a robot plate which is permanently
attached to the robot through a wrist adapter plate
and a mating rear plate which is part of the Evolver
303 Spray Applicator assembly. The applicator
is secured to the robot plate with a threaded re-
taining ring.
ELECTRICAL AND FIBER
OPTIC CONNECTIONS
The fiber optic cable is included in the Evolver 303
tubing bundle, but not used. It is there, ready to
use, in case a user is using or chooses to use in
the future, a bell applicator, which requires the fiber
optic cable. The fiber optic connection is made on
the back of the applicator's robot plate. The fiber
optic cable comes preassembled with connectors
that are secured in place by set screws tightened
from the side of the robot plate. An adequate
ground must be provided to the mounting plate to
ensure that fluid fittings, etc. are at ground potential.
FLUID CONNECTIONS
The paint, solvent, and dump fluid tubing are con-
nected on the back of the robot plate with stainless
steel compression fittings and PFA tubing. Fluid
tubing requirements are shown in the "Signal
Identification Tables" in the "Installation" section.
TYPICAL INSTALLATION
Figure 4 shows a typical installation of the Evolver
303 and the wiring installation of the applicator
with the MicroPak.
15
Evolver 303 Robotic Atomizers - Installation
Ransburg
AA-07-03.2