Ransburg Evolver 303 Solvent Applicator A11976-XXX - Manual (Page 10)

The Evolver 303 Spray Applicator System consists
of four major components:
1. Quick-Disconnect Spray Head
2. Gun Head Mounting Block Assembly
3. Valve Manifold Assembly (Includes the High
Voltage Cascade with a Quick-Disconnect
Ring)
4. Rear Tubing Manifold Assembly (both English
and Metric)
The spray head(s) and valve manifold contain
the fluid, air, and high voltage passages. All fluid
passages contain stainless steel and/or nylon
fittings, compatible with halogenated hydrocar-
bon solvents. The robot manifold incorporates
stainless steel fluid connections.
The high voltage cascade is entirely encapsulat-
ed with a solvent resistant epoxy. This cascade
generates voltages up to 100 kV fed by a low
voltage cable.
There are three sources for the high voltage
supply to the Evolver 303 Applicators:
• MicroPak™ Control Unit (LECU5004)
• Stand-alone control/power supply unit
(A10406)
• MicroPak TM Control Unit (LECU5004-31)
The MicroPak Power Supply Control unit provides
a low voltage signal through the robot manifold to
the spray applicator. The high voltage cascade
located within the applicator converts the low
voltage DC signal to a high voltage electrostatic
output.
NOTES
7
Evolver 303 Robotic Atomizers - Introduction
Ransburg
AA-07-03.2