E-Mon E-PS-E-RTU-N - Manual (Page 93)

Chapter 5 Configuring the PowerSmart+ PQM Configuring Meter Security
PowerSmart+ Power Quality Meter 93
To change the password:
1. Select the Password Setup entry from the Device Setup menu
using the UP/ DOWN buttons.
2. Press the ENTER button to enter the "Password Setup" menu.
3. Select "Password Value" with the UP /DOWN and ENTER
buttons to access the password value field.
4. select the desired digit using the UP/DOWN button and move
to next digit by pressing the TAB button
5. Press ENTER button when desired password value is achieved
that returns to "Password Value" field
The new password is effective for both the display and
communication ports.
To enable or disable password protection:
1. Select "Password Enabled" field using the UP /DOWN buttons.
2. Press the ENTER button to enter the "OFF/ON Password
Enabled" display.
3. Use the UP/DOWN buttons to select the option:
ON enables password protection and OFF disables password
protection.
4. Press ENTER to confirm your new setting.
5. Press ESC to exit the menu.
When password protection is enabled, you are not able
to change the device settings through the display or
communications unless you provide a correct password.
If you cannot provide a proper password, contact your
local distributor for the appropriate password to override
password protection.