E-Mon E-PS-E-RTU-N - Manual (Page 21)

Chapter 2 Installation Electrical Installation
PowerSmart+ Power Quality Meter 21
2.4 Electrical Installation
The equipment installation shall conform to the following
instructions:
a) a switch or circuit-breaker shall be included in the building
installation;
b) It shall be in close proximity to the equipment and within
easy reach of the OPERATOR;
c) It shall be marked as the disconnecting device for the
equipment.
Before installing, ensure that all incoming power sources
are shut OFF. Failure to observe this practice can result in
serious or even fatal injury and damage to equipment.
Typical Installation
Figure 2-6 Typical Installation Diagram